Ian Dalton Posted September 15, 2021 Share Posted September 15, 2021 I often use View Source with IE on my html pages that shows both html and WebFocus code. Now with Edge the View Page Source shows the html (WebFOCUS Portal) but not the code (WFservlet) - any suggestions Link to comment Share on other sites More sharing options...
Manoj Chaurasia Posted September 15, 2021 Share Posted September 15, 2021 Hi Ian I used EDGE Version 93.0.961.47 and put a -SET &ECHO=ALL; in my code and when I used View page source I did see my WebFOCUS code. However it wasnt at the bottom like I usually find it but in the middle of what is my report output Link to comment Share on other sites More sharing options...
Warren Hinchliffe Posted September 16, 2021 Share Posted September 16, 2021 Depending on the WebFOCUS version, there also may be a setting in the admin console that could be turning off echoing. If its set to Off then you may not see anything in the view source admin_echo.PNG115275 8.67 KB Link to comment Share on other sites More sharing options...
Toby Mills Posted September 16, 2021 Share Posted September 16, 2021 It might also be that your mouse is not in the right html frame when you do your view source Other options - I sometimes use the F12 debugger (network traffic) for this and Im a fan of Fiddler if your organization allows it. Link to comment Share on other sites More sharing options...
Ian Dalton Posted September 21, 2021 Author Share Posted September 21, 2021 Thanks Waz. We are on 8.1.05 but where is the setting exactly within the Admin Console Link to comment Share on other sites More sharing options...
Ian Dalton Posted September 21, 2021 Author Share Posted September 21, 2021 Thanks Toby but its a bit hit and miss - sometimes source is there with -SET &ECHO=ALL; but not always. I will experiment !! Link to comment Share on other sites More sharing options...
Warren Hinchliffe Posted September 21, 2021 Share Posted September 21, 2021 Hi Ian, Not sure if its in 8105. For 8207 its in Configuration / Application Settings / Other Link to comment Share on other sites More sharing options...
Ian Dalton Posted July 7, 2022 Author Share Posted July 7, 2022 Also have just discovered in Edge by right-clicking on View Frame Source you get all the html and webfocus code. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now